Ignition Curve Plug-In Connector; Adjusting The Ignition Curve To The Fuel Quality - KTM 990 Adventure 2009 Owner's Manual

Table of Contents

Advertisement

MAINTENANCE WORK ON CHASSIS AND ENGINE

Ignition curve plug-in connector

9.87

Adjusting the ignition curve to the fuel quality

9.88
Switch off the ignition by turning the black ignition key to the position
Remove the seat. (
p. 67)
To activate the ignition curve for low octane fuel:
Note
Engine damage Low-quality fuel damages the engine.
Operate the vehicle with fuel with an octane rating below 95 (ROZ 95 / RON 95 / PON 91) for no more than one tank full.
The ignition curve must be adjusted to low octane fuel.
Info
For optimal performance of the engine oil, do not mix different types of engine
oil.
We recommend changing the engine oil, if necessary.
Replace the oil dipstick.
Plug-in connector
is attached.
By disconnecting the plug-in connector, the ignition curve for fuel with an octane rating
below 95 (ROZ 95 / RON 95 / PON 91) is activated. While the engine will have a slightly
lower power output, this setting prevents engine damage by hindering spark knocking due
to poor fuel quality.
Possible states
Plug-in connector disconnected – Fuel with an octane rating of 80 to 94 (RON) can be
used for one tank full.
Plug-in connector connected – Fuel with an octane rating of 95 or higher can be used.
100554-10
is located under the seat close to where the top of the shock absorber
.
162

Advertisement

Table of Contents
loading

Table of Contents