Pbx Connection; Programming The Public Access Code; Call Transfer By Replacing The Handset - ASCOM Eurit 30 Operating Manual

PBX connection

The following should be taken into account when operating the Eurit 30 in conjunction with a
PBX.
For detailed information on the following, please refer to your PBX operating manual.

Programming the public access code

When the telephone is operated in conjunction with a PBX, the public access code may have to be
programmed to ensure, for instance, that the numbers on the caller list are dialled correctly.
Installation
Public access:
change
Public access:
ok
If you have programmed the public access code you can omit it (but not the prefix)
when entering numbers in the name list and under auto-dial keys.
The public access code is not automatically dialled when you dial using the keypad.

Call transfer by replacing the handset

When operating a telephone in conjunction with a PBX you can transfer a call by replacing the
handset (=forward). This function is not supported by all PBXs. To program this function, proceed
as follows:
Installation
ECT: off
change
ECT: off
ok on
"ECT off" (ex-factory status) means that you disconnect the active call when replacing
the handset (the call on hold is signalled).
"ECT on" means that the call is transferred when the handset is replaced.
You can also transfer a call by pressing the preprogrammed auto-dial key (see section
on "Programming auto-dial keys").
Press the MENU key until menu item "Installation"
appears. Press the Foxkey under
appears.
Press the Foxkey under "change".
Enter the public access code (max. 4 digits).
(Press the Foxkey under "del" to delete the current public
access code).
Press the Foxkey under "ok" to store the public access
code.
del
Press the MENU key until "Installation" appears. Press the
Foxkey under
Press the Foxkey under "change".
Press the Foxkey under "on" and "ok" to activate this
function.
27
until "Public access"
until "ECT" appears.