Wheel Brush - Grizzly G0664 Owner's Manual

Wheel Brush

the Model g0664 is equipped with a wire wheel
brush to clean metal chips from the blade, reduc-
ing wear to the blade and machine. With use, the
wheel will wear requiring adjustment and eventual
replacement.
To adjust/replace the wheel brush:
1. raise the bow to the upmost position to allow
the best access to the wheel brush.
2.
disConneCt BandsaW FroM poWer!
3. support the wheel brush so it doesn't fall,
then loosen the two phillip head screws that
secure the wheel brush (figure 55).
-48-
phillip head screws
Wheel Brush
figure 55. Wheel brush.
4. adjust the brush so that the blade extends
approximately ⁄ " into the brush bristles.
1
8
—if the brush cannot be adjusted to this spec-
ification due to wear, it must be replaced.
remove the old wheel brush and position
a new one as outlined in Step 4.
5. tighten the phillip head screws to secure the
wheel brush.
g0664 heavy duty Metal-Cutting Bandsaw