Swivel Stops - Grizzly G0664 Owner's Manual

Swivel Stops

the blade swivel stops are factory set. however,
due to shipping and storage we recommend that
you check the 0°, -45° and the 60° stops yourself
to ensure the cuts will to be your standards. Note:
The accuracy range for the scale is ±
To adjust the swivel stops:
1. Make sure the blade is oiled, tensioned, and
tracking correctly, and that the guides are
set.
2.
disConneCt BandsaW FroM poWer!
3.
raise the bow, move and lock the headstock
to 0° (figure 60), then lower the bow.
figure 60. Bow and headstock moved to zero.
4.
observe the scale, and if the headstock is not
at 0°, adjust the zero stop (figure 61) so it will
line up with the mark.
zero stop
figure 61. zero degree swivel stop.
-50-
5.
6.
⁄ ° degree.
1
2
7.
8.
0° Mark
9.
Move the headstock to 60°.
read the scale. the bandsaw blade should
be at 60°.
—if the headstock is not at 60°, adjust the
stop (figure 62) so it will line up with the
60° mark.
60° stop Bolt
60° stop Bolt location
figure 62. 60° swivel stop.
Move and the headstock to -45°.
read the scale. the bandsaw blade should
be at -45°.
—if the headstock is not at -45°, adjust the
stop (figure 63) so it will line up with the
-45° mark.
45° stop Bolt
figure 63. 45° swivel stop.
go to Squaring Blade on page 49 to make
sure the cuts will be perpendicular to the
table.
g0664 heavy duty Metal-Cutting Bandsaw