SEcTiON 6: MAiNTENANcE
Always disconnect power
to the machine before
performing maintenance.
failure to do this may
result in serious person-
al injury.
Schedule
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Daily check:
•
loose mounting bolts.
•
damaged saw blade.
•
Worn or damaged wires.
•
any other unsafe condition.
•
Clean wheel brushes.
•
Clean bearings.
Monthly check:
•
v-belt tension, damage, or wear.
•
Clean/vacuum dust buildup from inside cabi-
net and off motor.
-38-
cleaning
Cleaning the Model g0513/g0514 is relatively
easy. vacuum excess wood chips and sawdust,
and wipe off the remaining dust with a dry cloth.
if any resin has built up, use a resin dissolving
cleaner to remove it. treat all unpainted cast iron
and steel with a non-staining lubricant after clean-
ing.
Unpainted cast iron
protect the unpainted cast iron surfaces on the
table by wiping the table clean after every use—
this ensures moisture from wood dust does not
remain on bare metal surfaces.
Keep tables rust-free with regular applications of
products like g96
gun treatment, slipit
®
t-9 (see Section 5: Accessories on
Boeshield
®
page 36 for more details).
Wheel Brush
the bandsaw is equipped with lower wheel brush-
es. the brushes should be checked daily and
cleaned when it becomes dirty. each brush has
an adjustment bracket that allows it to be adjusted
for bristle wear. refer to Adjusting Wheel Brush
on page 46 for adjustment details.
Model g0513/g0514 (Mfg. 8/02+)
, or
®