Before Turning On The Power; Initial Auto Installation - Triax TSC 114 Operating Manual

Quick Guide

Before turning on the power

1
1 Connect the antenna (Coaxial Plug), 75ohm coaxial
cable, (CAI Benchmarked cable such as Triax TX100)
2 Connect the satellite dish (F-Type Plug), 75ohm coaxial cable,
(CAI Benchmarked cable such as Triax TX100)
3 Connect the HDMI cable
4 Connect the power adaptor and switch on at the socket

Initial auto installation

When the Receiver is powered on for the first time, the Initial Installation screen appears.
Follow the on-screen instructions to search for all available channels.
Confirm the following before turning on the power
• Are the Terrestrial and Satellite cables connected?
• Is the power adapter connected and plugged in?
• Is the HDMI cable connected between the receiver and your TV?
1 Ensure the aerial and satellite cables are connected before switching on.
2 Press the enter key on the Receiver or Remote Control.
• The Initial Installation screen is displayed.
3 Highlight Start Search, and press ENTER to start the channel search.
•
The Receiver will search for, sort and store all Terrestrial channels according to their LCN numbers.
NOTE
• After the Initial Installation has been completed,
the default PIN is automatically set to '0000'.
To change the PIN setting, refer to Page 25.
2
3
9
4