Troubleshooting - Scooter Takes Off, Will Not Stop; Troubleshooting - Blinkers Do Not Work - X-TREME X-370 Owner's Manual

Troubleshooting:
Scooter Takes Off – Will Not Stop
A) If the scooter is moving when you turn the key to the "on" position without turning the
throttle you will need to replace the throttle or controller.
B) If scooter takes off without turning the key to "on" – you need to replace the controller.
Scooter is not moving and the lights do not work using battery, but lights do work when
you plug the charger into the side of the scooter and also plug the charger into the
wall-Scooter will not move at all and all lights do not work (lights do work when you plug
the charger into wall):
A) No fuse in fuse assembly= add one of the fuses includes with the scooters
B) Bad Fuse= unscrew the cap only on the fuse holder. Remove the fuse and make sure
that the fuse is not blown (a good fuse will have a solid wire from one end to the other, a
bad fuse=the wire inside is broken).
C) Bad fuse holder = fuse assembly may be cracked or have a bad connection within it.
D) Bad controller box
E) Possibly bad battery, although this is rare.
F) Wires behind fuse assembly have come off due to improper replacement of fuses or
loose wire connections to the battery. This is always due to the customer rotating the
whole fuse assembly (when changing fuses) and twisting the 2 wires that are in the back
of the fuse holder. You must open up scooter and reattach these wires to back of fuse
assembly or to battery and control box. If this is the problem the lights WILL work when
you have the charger plugged in.
Troubleshooting:
Blinkers Do Not Work
1. Open the battery cover and locate the blinker module. This is a blue or black devise that
has 2 wires attached to it and is approximately 1 ½ inches tall.
2. Ensure both wires are connected.
3. If both wires are connected and the blinker still does not operate, module may be bad.
33