How To Remove Free Wheel Clutch; How To Test Motor Direct To Battery - X-TREME X-370 Owner's Manual

back down onto the cable.
- Next fine tune the adjustment by screwing the cable tension screw outward to pull on
brake line until proper braking is achieved.
- Lock this position down by tightening the nuts.
- Avoid adjusting brakes on handlebars because there is a safety switch built into the
handles to kill motor while using the brakes.

How To Remove Free Wheel Clutch

To remove your free wheel you must first remove the rear wheel from the scooter then
proceed to the directions below.
1. Remove the sprocket from the free wheel.
2. Place penetrating oil (WD-40) where the free wheel and wheel hub meet. Let it set over
night.
3. Use a small punch or place the edge of a regular screwdriver into one of the small holes
in the face of the free wheel.
4. Take a hammer and strike the screwdriver driving the free wheel counterclockwise.
5. Remove the free wheel from the wheel hub.
6. Install the new free wheel by hand with the writing side out.
** Do not tighten the free wheel by striking with a screwdriver and hammer.
7. Reassemble everything in reverse order.

How To Test Motor Direct To Battery

** ATTENTION: Prop the scooter up so that the rear wheel is NOT touching the
ground. In this test the drive wheel will run Full Speed.
1) Access the Battery and Controller compartment.
2) Locate the Connector from the Battery to the Controller and label the male & female
sides for reference.
2) Locate the Connector coming from the Motor to the Controller and label the male &
female sides for reference.
3) Unplug the Batter and Motor connectors and plug them directly into each other.
**Caution** This will bypass the controller and put power directly to the motor.
If the Motor is good and the Batteries are charged the wheel will spin at full power in which
case the Controller may need to be replaced.
If the Motor did not run then the Batteries will need to be checked to confirm they are
holding a charge.
If Batteries are holding a charge then the Motor will need to be checked or replaced.
24