Failure to follow these INSTRUCTIONS will VOID YOUR WARRANTY! This PRODUCT IS NOT INTENDED FOR EXTREME or OFF-ROAD Use! Please take care of your X-140! DO NOT JUMP or ABUSE THIS PRODUCT! DO NOT RIDE IN WET/ICY CONDITIONS! Failure to follow these instructions will...
Page 3
IMPORTANT PLEASE READ THIS BEFORE USING THIS PRODUCT READ THIS FIRST! WARNING This product does not conform to Federal Motor Vehicle Standards and is not intended for operation on public streets, roads or highways. Serious injury can result from the unsafe operations of this product. Operator can minimize these risks by using certain safety equipment such as: safety helmet, goggles, gloves, elbow and kneepads and appropriate footwear.
Avoid unintentional starts by turning the scooter off while not in use. To avoid the risk of a short circuit in the electrical parts, do not use your X-Treme Electric scooter in the rain and never spray or wash off your scooter with water. ...
PACKAGE CONTENTS Your X-Treme X-140 comes with the following items in the box. Please locate all of the following: The X-Treme X-140 Scooter 24V Battery Charger Tool Kit Product Handbook GETTING STARTED Please read and understand these instructions and the OPERATING...
Fuse Installation Your scooter comes with a 20amp fuse that may need installed if not done so already at the factory. Follow the instructions below to properly install the fuse before attempting to use your scooter. Locate the 20amp glass fuse that came with your scooter. Locate the fuse holder on the front of the scooter frame under the footplate.
3. Push the on/off switch (located on the left side of the scooter frame under the footplate) to the ON position. 4. Put one foot on the deck of the X-140 while pushing off with the other foot, gently rotate the THROTTLE GRIP, on the right side of the handlebars. The X-140 will begin to move on its own power.
With continued use the squeak should go away. TIRE AND WHEELS The X-Treme X-140 used different rim and tire assemblies on the front and rear wheels. Front wheel is a hard rubber wheel. The back wheel is a hard rosin wheel.
MAINTENANCE RECOMMENDED TOOLS To adjust and service the X-Treme X-140 you will need the following tools: Allen Wrenches: 3/4/5/6 mm Wrenches: 8/10/13 mm Open end wrench Large Adjustable Crescent Wrench Philips Head Screwdrivers Oil, Grease or Lubricant ADJUSTING THE BELT The belt will come adjusted from the factory.
For additional questions, service instructions, further information and important phone numbers, please go to the X-Treme website at www.x-tremescooters.com Thank you for purchasing an X-Treme X-140 and please tell your friends how much fun you’re having on the X-Treme X-140...
DO NOT RETURN TO STORE! IF YOU NEED HELP CALL TOLL FREE OR GO ONLINE 1-800-772-3852 www.x-tremescooters.com/support/ For General Information or Parts Visit www.x-tremescooters.com REVISED 3/19/10 Page13...