Table of Contents
Advertisement
Miter Body
Set the miter body onto its pivot hole and secure
into place with the plastic lock knob provided.
See Figure 12. The miter body should only be
used when sanding the ends of workpieces at
least 8'' long. Do not use it as a back stop.
Figure 12. Attaching the miter body.
Be certain that this machine is properly
grounded before attempting to use it. If you
are unsure of the quality and condition of
the circuit you intend to use, have it inspect-
ed and repaired by a qualified electrician.
Failure to ensure proper grounding could
result in fatal or serious injury and/or equip-
ment damage.
Make your workshop child-safe. Ensure that
idle machines have their safety keys
removed, sharp blades are stored safely
out of reach, and that your shop is securely
locked when your shop is not in use.
-12-
Quick Release Lever
1.
Loosen the belt tracking lock knob located at
the top left of the machine.
2.
Slide the quick release lever through the slot
on the top of the platen cover. Thread it into
place until it bottoms out. See Figure 13. It
may be necessary to have an assistant push
the idler roller back into the machine to allow
the quick release lever to line up with the
thread in the yoke.
Figure 13. Installing the quick release lever.
Operating this equipment has the potential
to propel debris into the air which can
cause eye injury. Always wear safety glass-
es or goggles when operating equipment.
Everyday glasses or reading glasses only
have impact resistant lenses, they are not
safety glasses. Be certain the safety glass-
es you wear meet the appropriate stan-
dards of the American National Standards
Institute (ANSI).
G1140 Edge Sander
Advertisement
Table of Contents
