Clean Up; Site Considerations - Grizzly G0574 Manual Insert

Clean Up

The unpainted surfaces are coated with a waxy
oil to protect it from corrosion during shipment.
Remove this protective coating with a solvent
cleaner or citrus-based degreaser. Avoid chlo-
rine-based solvents as they may damage painted
surfaces should they come in contact. Always fol-
low the usage instructions on the product you
choose for clean up.
Many of the solvents commonly used to
clean machinery can be highly flammable,
and toxic when inhaled or ingested. Always
work in well-ventilated areas far from
potential ignition sources when dealing
with solvents. Use care when disposing of
waste rags and towels to be sure they do
not create fire or environmental hazards.
Keep children and animals safely away
when cleaning and
machine.
Do not use gasoline or other petroleum-
based solvents to remove this protective
coating. These products generally have low
flash points which makes them extremely
flammable. A risk of explosion and burning
exists if these products are used. Serious
personal injury may occur.
All die-cut metal parts have a sharp edge
(called "flashing") on them after they are
formed. This is generally removed at the
factory. Sometimes a bit of flashing might
escape inspection, and the sharp edge may
cause cuts or lacerations when handled.
Please examine the edges of all die-cut
metal parts and file or sand the edge to
remove the flashing before handling.
-8-
assembling this

Site Considerations

1. Floor Load: Your G1140 Sander represents
a large weight load in a small footprint. Most
commercial floors are suitable for the Model
G1140. Some residential floors may require
additional build up to support both machine
and operator.
2. Working Clearances: Consider existing and
anticipated needs, size of material to be
processed through each machine, and
space for auxiliary stands, work tables or
other machinery when establishing a home
for your edge sander. Allow sufficient room
to safely run your machines in any foresee-
able operation.
3. Lighting and Outlets: Lighting should be
bright enough to eliminate shadow and pre-
vent eye strain. Electrical circuits should be
dedicated or large enough to handle amper-
age requirements. Outlets should be located
near each machine so power or extension
cords are clear of high-traffic areas. Observe
local electrical codes for proper installation
of new lighting, outlets, or circuits.
Be certain that this machine is properly
grounded before attempting to use it. If you
are unsure of the quality and condition of
the circuit you intend to use, have it inspect-
ed and repaired by a qualified electrician.
NOTICE
Ensure that the Model G1140 is located on a
flat, level surface. This will maximize the
stability of the machine and ensure that
adjustments are accurate. For conditions
where permanent mounting is possible, we
recommend bolting the Edge Sander to
your floor. This type of mounting will mini-
mize vibration and provide a more stable
work environment.
G1140 Edge Sander