Back Stop
Attach the back stop as shown in Figure 16. Set
the back stop no more than
per. This will prevent objects from being jammed
between the back stop and the platen causing a
potentially dangerous situation.
Figure 16. Back stop properly installed.
DO NOT attempt to operate this machine
without this back stop in place and properly
adjusted as described above. An improper
gap between the stop and the belt can cre-
ate a situation where a finger or hand can
get trapped against the moving belt.
Serious injury could occur.
-14-
1
⁄
'' from the sandpa-
8
Belt Installation
1.
Loosen the belt tracking lock knob on the top
left of the machine. Open the lid of the dust
port and move the quick release lever to its
locked open position. See Figure 17.
Figure 17. Sander ready for belt installation.
2.
Check the back side of the belt for an arrow
indicating direction of rotation. The sanding
belt rotates counter-clockwise.
3.
Slide the belt over the rollers. Move the quick
release lever back to its tensioned position.
See Figure 18. Belt tracking is covered in
the next section.
Figure 18. Belt installed.
G1140 Edge Sander