External 5.25" Device Installation - Antec Three Hundred Two User Manual

2.6

External 5.25" Device Installation

The Three Hundred Two can support up to three 5.25" devices.
1. Remove the side panels and front bezel as directed in Section 2.2.
2. Remove the drive bay cover by pressing in on the four small tabs on either side of the cover,
then push cover out the front of the bezel.
3. Replace the front bezel on the front of the chassis.
4. Slide your 5.25" drive through the front of the chassis until it lines up flush with the front bezel.
You will feel the drive lock into position.
5. If you need more clearance on the inside of the chassis for your drive, pull the drive bay tab on
the inside of the chassis toward you and push the drive in further.
Slide you drive until it locks.
Press down on the drive cover tabs.
11
Pull on the tab to adjust drive bay clearance.
Remove the drive bay cover.