Table of Contents
Advertisement
2.7 E
5.25" D
XTERNAL
EVICE
There are three externally accessible 5.25" drive bays. Before you begin,
remove both side panels and front bezel as detailed in section 2.1.
1.
Remove the drive bay faceplate by applying pressure to the inside
of the plate until it pops free of the bezel.
2.
Slide your 5.25" device into the bay from the front of the case.
3.
Secure the drive into position in the drive cage using the provided
screws.
4.
Mount any other 5.25" devices accordingly.
5.
Connect the appropriate power and data cables to your device(s).
2.8 I
2.5" D
NTERNAL
EVICE
At the bottom of your case, there are mounting holes designed to support one 2.5" SSD device. Before
you begin, remove both side panels and front bezel as detailed in section 2.1.
1. Remove four silicon grommets from the tool box. Install
them in the four holes at the base of the case at the
bottom of the drive bay area. You should install them
with the thick part of the grommets facing the inside of
the case.
2. Rest your 2.5" device on the grommets, making sure that
the screw holes on the device are aligned with the
grommets.
3. Secure the device to the case with the screws provided.
4. Connect the appropriate power and data cables to your
device
Note: Do not torque or over-tighten the 3.5" internal
drive tray screws. Compressing the screws against
the silicone grommets will reduce their lifespan
and will lessen or negate their vibration-insulating
effect. Tighten the screws until you feel
resistance, then stop.
I
NSTALLATION
I
NSTALLATION
7
Hide quick links:
Advertisement
Table of Contents
