Advertisement
Locate the internal audio connectors from the motherboard or sound card.
Consult the motherboard or sound card manual for the pin-out positions.
1. Microphone Signal Pin: Connect the MIC connector to this pin.
2. Microphone Power: Connect the MIC-BIAS connector to this pin.
3. Ground Pin: Connect the AUD GND connector to this pin.
4. Front Right Speaker Out Pin: Connect the FPOUT-R connector to this pin.
5. Front Left Speaker Out Pin: Connect the FPOUT-L connector to this pin.
6. Rear Right Speaker Out Pin: Connect the RET-R connector to this pin.
7. Rear Left Speaker Out Pin: Connect RET-L connector to this pin.
3.5" Device Installation
There is a 5.25" to 3.5" drive bay adapter installed inside the lowest 5.25" drive
bay. Use this for the floppy drive or other external 3.5" device.
1. Remove the lowest 5.25" drive bay cover that has a 3.5" drive bay cover in it
from the bezel.
2. Remove the 3.5" cover from it.
3. Loose the two screws that fasten the adapter to the drive bay and slide the
adapter out through the front of the case.
4. Mount the floppy drive or other external device into the adapter.
5. Slide and fasten the adapter back into the case.
6. Find a small 4-pin power connector on the power supply and connect it to the
male 4-pin connector on the device.
7. Reinstall the drive bay cover back to the bezel.
There is a HDD cage under the external 5.25" drive bays for hard drives. Inside the
cage there are five HDD bays. Each comes with an individual drive tray with soft
silicone grommets to absorb and isolate the HDD noise.
1. Loose the two thumb screws from the HDD cage.
2. Slide the HDD cage out from the case.
3. Squeeze the metal clips on each side of the tray and slide the tray out.
4. Mount the hard drive into the drive tray through the bottom silicone grommets
with the special screws provided. Note: Don't over-tighten the screws.
Doing so will reduce the vibration and noise-dampening ability of the rubber
grommets.
5. Slide and lock the tray back into the case.
6. Repeat the same procedure for the other devices as necessary. Note: If you
choose to install the optional front 92mm fans to the case, please do it now.
See the instructions under "Cooling System" for more information.
7. Slide the HDD cage back to the case and fasten the two thumbscrews.
8. Find the appropriate power connector on the power supply and connect it to
the connector on the device.
5.25" Device Installation
There are four external 5.25" drive bays (one with 5.25" to 3.5" Adapter).
1. Remove the left side panel of the case.
2. Remove the plastic cover for the drive bay you want to use.
3. Slide the drive into the bay from the front of the case.
4. Fasten the drive using the screws provided in the tool bag.
Note: you need only to fasten the drive through the open side of the drive bay.
4
Advertisement
