Advertisement
2. Microphone Power: Connect the MIC-BIAS connector to this pin.
3. Ground Pin: Connect the AUD GND connector to this pin.
4. Front Right Speaker Out Pin: Connect the FPOUT-R connector to this pin.
5. Front Right Speaker Out Pin: Connect the FPOUT-L connector to this pin.
6. Rear Right Speaker Out Pin: Connect the RET-R connector to this pin.
7. Rear Left Speaker Out Pin: Connect RET-L connector to this pin.
INSTALLING 3.5" DEVICES
There are two external 3/5" drive bays right under the 5.25" drive bays. Press the two metal tabs
on the sides of the 3.5" drive tray and pull the 3.5" drive tray out of the case. You may wish to
open the bezel door to facilitate this.
1. Remove the drive bay cover from the drive bay that you intend to install the drive.
2. Mount your floppy drive or other external device into the drive bay. Repeat the same
procedure for the other drive as necessary.
3. Slide and lock the drive tray back into the case.
4. Find a small 4-pin power connector on the power supply and connect it to the male 4-pin
connector on the device.
There are 4 internal drive bays right under the external 3.5" drive bays for hard drives. Each comes
with an individual drive tray which mounts through the open side panel of the case.
1. Squeeze the metal clips on each side of the tray and slide the tray out.
2. Mount your hard drive or other internal 3.5" device into the drive tray through the bottom
rubber grommets with the special screws provided. Note: Don't over-tighten.
Over-tightening the screws will harm the vibration and noise reducing ability of the rubber
grommets.
3. Slide and lock the tray back into the case.
4. Find a peripherial power molex connector on the power supply and connect it to the male
4-pin connector on the device.
5. Repeat the same procedure for the other devices as necessary.
Note: You can mount the drives with either the connectors facing you or away from you. If
you mount them with the connectors facing away from you (into the case) you may wish to
connect the data cables before sliding the drive into the locked position.
Note: Mounting the drives with the connectors facing you (towards the open side of the case)
may make squeezing the release clips more difficult.
5.25" DEVICE INSTALLATION
There are three 5.25" drive bays. Each drive bay comes with a plastic cover with two drive rails
attached behind the cover.
1. Remove the plastic drive bay cover and remover the drive rails from the cover. You may wish
to open the bezel door to facilitate this.
2. Mount the drive rails onto the sides of the 5.25" device. Make sure the metal tabs are angled
on the outside and facing towards the front of the device.
3. Slide the device into the drive bay until you hear a click.
4. Mount the other devices accordingly.
5. Connect a peripherial power connector from the power supply to the male connector on
each of the devices.
6
Advertisement
