External 5.25" Device Installation - Antec P100 User Manual

2.5

External 5.25" Device Installation

To install a 5.25" drive, you will need to remove the side panel and open the front door. For side panel
removal, please see Section 2.1.
1. With the side panel off, carefully push the drive bay cover out of the drive bay.
2. Slide your 5.25" drive through the front of the chassis until it lines up flush with the front bezel.
You will feel the drive lock into position.
3. If you need more clearance on the inside of the chassis for your drive, pull the drive bay tab on
the inside of the chassis toward you and push the drive in further.
A
To install a 5.25" drive, begin by opening the
C
13
front door.
(See step 3 above if you need more clearance
B
Make sure to also remove the side panel as well
(see Section 2.1 for more information)
for your drive.)