Quick Release Device Installation - Antec SKELETON User Manual

3. Slide the plate-mounted power supply into the bottom level of the Component
Tray until it locks into position. There are two possible locations to mount the
power supply, depending on the size of your equipment.
Note: Power supplies equipped with an 80mm fan will draw air through the Skeleton
and power supply more effectively. We recommend power supplies such as Antec's
TruePower Quattro or Signature series power supplies. However, if using a power
supply with a 120mm fan, ensure that the power supply fan will face the top of the
case when installed.

2.6 5.25" Quick Release Device Installation

1. Find the tool bag marked "For 5.25" device" which contains round, silver-headed
screws. Align one of the screws with your 5.25" device. For the upper 5.25"
drive bay, fasten the screw to the right side, lower front screw hole. For the
lower 5.25" device, fasten the screw to the right side, upper front screw hole.
2. While facing the front of the case, insert your 5.25" device into the corresponding
slot in the Component Tray until it locks into position.
3. Connect the data and power connectors from the motherboard and power
supply to the device.
Note: It may be necessary to remove the motherboard tray and/or side screens as
detailed in sections 2.2 and 2.3 to effectively route cables to your device.
2.7 3.5" Quick Release Device Installation
1. Find the tool bag marked "For HDD" which contains round, black-headed screws.
Fasten one of the screws to your 3.5" device in the front left screw hole.
2. While facing the front of the case, depress the two tabs on the top of the
92mm fan casing and detach it from the front of the hard drive housing.
3. Insert your 3.5" device into the corresponding slot until it locks into position,
then replace the 92mm fan housing.
6