Table of Contents
Advertisement
Section 8: Removing & Installing the Screen / Door
Removing the Screen
Follow the steps below to remove, or install the fireplace screen and
door. Before beginning any screen or glass removal, make sure that the
unit has not been in operation and that it is at room temperature.
Step 1: Locate the three tabs at the base of the screen.
Figure 20. Locate the three tabs at the base of the screen
Step 2: Lift out the Retaining Tabs and screen.
Pull the bottom of the screen outward, then slide out the screen from
the frame.
Store in a safe place. The Screen is very fragile and can be easily torn,
dented or deformed. Refer to Figure 20.b below.
Figure 20.b Lift out the Retaining Tabs and screen
Reinstalling the Screen
Follow the two previous steps to re-install the fireplace window.
NOTICE
Any safety screen, guard, or barrier removed for servicing an
appliance, must be replaced prior to operating the appliance
28
Removing the door
The Distinction doors are removed in a few simple steps. Follow these
steps below to unlatch the door buckles and remove the door.
STEP 1:
Remove lower valve blinds and screen setting bar.
STEP 2:
Ensure the tool is firmly
in the lower end of the
slot, (as shown), Then
pull toward you, door will
unlatch, repeat for other
buckles.
Figure 21.d Pull door latches
STEP 3:
With glass lifting tool (if
needed), pull the top of
the door towards you,
then lift the door up
and out of the fireplace
frame. Store in a safe
place.
Figure 21.e Lift the door
Reinstalling the door
NOTE: Make sure the top and base of the door slips into the narrow
channel in the frame to ensure proper placement.
STEP 1:
The upper frame of the
door is pushed into the
top channel before the
bottom is pushed into
place.
Figure 21.b Installing the door
STEP 2:
Buckles are locked into
place by pulling out and
up, latch will pop into
place.
Figure 21.d Pull door latches
Installation
XG0222
Advertisement
Table of Contents
