Connecting Dc Wiring For A Single Battery Or Multiple Batteries - Xantrex Truecharge TC20+ Owner's Manual

Connecting DC Wiring For A Single Battery Or Multiple Batteries

The procedure for installing the DC wiring applies to a single battery or
multiple batteries or battery banks.
order.
Status Charging Current (A)
R eady
Charging
1 3 5 10 20
Equalize
Charger Mode
Bulk/Absorption
Bulk/Absorption/Float 13.5V (fixed)
Battery Temperature
Battery Type
F looded
Cold Warm Hot
G el
14.8/13.9 14.4/13.5 14.0/13.1
A G M
14.6/14.2 14.2/13.8 13.8/13.4
14.6/13.7 14.3/13.4 14.0/13.1
Out put Volts
Absorption / Float
T M
3 -red
2 -red
1 -red
14-black
Figure 2-3 DC wiring connection order
WARNING
Truecharge+ cannot be set to deliver different charging
profiles at each output. Therefore all the batteries you are
charging must be the same type, that is, all should be flooded,
or all gel, or all AGM.
13
Installing Truecharge+
Figure 2-3 shows the connection
10
4
5
6
DC Negative Bus
11
12
9 8 7
2–9