Master/Slave Operation; Fixture Linking - Chauvet 4PLAY User Manual

Master/Slave Operation

This mode allows for multiple 4PLAY™ slave fixtures to follow a single master fixture. Please see the
following instructions for the setup.
1) Set the master fixture to one of the 2 standalone operating modes: automatic or sound mode.
Set the DMX starting address of the Slave(s) to "
3)

Fixture Linking

In order to use this fixture in a DMX or master/slave operation, you must daisy chain using DMX cables to link
from one fixture to another. In a master/slave operation, the DMX controller is not connected.
DMX controller
(only in DMX operation)
4. Operating Instructions
".
Additional signal
link out
11
Fixture #1
Fixture #2
Fixture #3
3/30/2010 3:40 PM