Mounting; Orientation; Rigging - Chauvet 4PLAY User Manual

Mounting

Orientation

The 4PLAY™ may be mounted in any safe position, provided there is adequate room for ventilation.

Rigging

Be sure that the structure can support the weight of the fixture. Please see the "Technical
Specifications" section of this manual for a detailed weight listing. Mount the fixture securely. This
may be done with a screw, nut and bolt, or a hanging clamp. The bolt in each bracket is 13 mm in
size. When rigging, consider routine maintenance and control panel access. Please see the following
steps for installation.
Mount Clamps Directly to the
fixture (minimum of 2 clamps)
3. Setup
If the power link out is intended to be used with multiple fixture, take into account the length
of each power cable, and mount the fixtures close enough to one another to accommodate
for this.
When aiming the fixtures, you may use the bracket adjustment knobs. Loosen the knob,
adjust to the desired angle, and then tighten the knob by turning clockwise. Do not use
tools for this step, as it may cause damage.
There are 2 different methods of mounting this fixture. This fixture may be used with a
tripod stand (sold separately), or it may be mounted to a structure using hanging clamps.
Safety cables must always be used.
2 clamps, one on either mounting position, must be used if using clamps mounted directly
to the fixture.
4BAR™
(sold separately)
4PLAY™
Tripod Stand
(sold separately)
(sold separately)
8 3/30/2010 3:40 PM