Light Addressing
The 4PLAY™ has 4 lights which must all be addressed. While these lights come preaddressed from the factory,
the section below demonstrates how to address them. This is important, so that they will operate properly.
Please see the instructions and drawings below for further details on how to set the DIP switches on each light.
Addressing:
Light #1: set only DIP switch #1 to the ON position
Light #2: set only DIP switch #2 to the ON position
Light #3: set only DIP switch #3 to the ON position
Light #4: set only DIP switch #4 to the ON position
Duplicating these addresses will cause the main light show to malfunction.
Back of each light
4. Operating Instructions
DIP switch settings
12
3/30/2010 3:40 PM