The Mx3Plus Hand Held Computer; Touchscreen Display; Applying The Protective Film To The Display; Display Backlight - LXE MX3Plus User Manual

Touchscreen Display

The Touchscreen Display is an LCD unit capable of supporting VGA graphics modes. Display
size is 640 x 240 pixels. The touchscreen allows signature capture and touch input. A pen stylus is
included. The touchscreen responds to an actuation force (touch) of 4 oz. of pressure (or greater).
The display type is either:

Applying the Protective Film to the Display

First, clean the display of fingerprints, lint particles, dust and smudges (see Cleaning the Glass
Display/Scanner Aperture).
Remove the protective film from its container. Remove any protective backing from the film sheet
by lifting the backing from a corner of the film. Discard the backing.
Apply the film to the screen starting at one side and smoothing it across the display. If air bubbles
appear, raise the film slightly and continue smoothing the film across the display until it covers the
glass surface of the display.
If dust, lint or smudges are trapped between the protective film and the glass display, remove the
protective film, clean the display and apply the protective film again.

Display Backlight

The Display backlight is turned on when the unit returns from Suspend Mode. The display
backlighting feature is programmable and activates based on power source and amount of idle
time before entering the Suspend state.
See the section titled Set the Display Backlight Timer in the previous section Quick Start.
E-EQ-MX3PLUSOGWW-B

The MX3Plus Hand Held Computer

Figure 21 Touchscreen Display
•
An active transmissive display optimized for indoor viewing, or
•
An active transflecive display optimized for outdoor viewing. A VX3Plus with this
display includes a "sun" logo to the bottom left of the keypad.
MX3Plus User's Guide