f. Press PROG
3. TO PROGRAM EMERGENCY TELEPHONE CALL NUMBERS
a. Enter password followed by PROG
b. MEMORY will flash on the auto-dialer screen. (Fig.6)
c. Press ARM/DISARM
d. You are now ready to program up to 5 emergency telephone numbers. Press the
*/UP
or #/DOWN
select 2 this is where your number will be stored and it will be the 2
dialed.
e. Enter the telephone number you would like to store, followed by
ARM/DISARM
digits).
f. Repeat steps C to E for the four other numbers you may wish to store.
g. Press PROG
4. TO DELETE A TELEPHONE NUMBER FROM MEMORY
a. Enter password followed by PROG
b. MEMORY will flash on the auto-dialer screen. (Fig.6)
c. Press ARM/DISARM
d. Press */UP
e. Press DEL./PAUSE
f. Press the ARM/DISARM
g. Press PROG
5. PAUSE FUNCTION
The "PAUSE" function can be stored as one digit in the telephone number memory for
some dialing operations. Every one PAUSE in the memory dialing sequence will pause for
3.6 seconds. For example, if you want to store telephone number 514-363-1030
EXTENSION 230 to memory location 2, the operation will be as following:
a. Enter password then press PROG
b. MEMORY will flash on the auto-dialer screen.
c. Press ARM/DISARM
d. Press */UP
Page 6 of 17 5/11/2012
button once (1) to exit set-up mode.
button to confirm.
buttons to select memory location from 1 to 5. If you
to confirm (maximum of 32 digits, but only displays last 16
button eight (8) times to exit the set-up
button to confirm.
or #/DOWN
buttons to select the number you want to delete.
button to delete the number.
button to confirm.
button eight (8) times to exit the set-up mode.
button to confirm.
or #/DOWN
button to select memory location 2.
button twice (2).
mode.
button twice (2).
button twice (2).
nd
number