Ideal Security SK633 Owner's Manual page 8

The auto-dialer has been factory pre-set for auto dialing for 1 cycle (When a sensor is
triggered the auto dialer will call all stored numbers 1 time. You can change this cycle from
1 to 5 dialing cycles.
a. Enter password followed by PROG
b. CYCLE will flash on the auto-dialer screen.
c. Press ARM/DISARM
d. Using */UP
followed by the ARM/DISARM
e. Press PROG
9. TO PROGRAM CALL-IN RING DETECT CYCLE (how many rings before auto
dialer will answer.
The auto dialer has been factory preset to answer on the 5
The call-in ring detect cycle is for how many times you want the phone to ring before the
auto-dialer picks up. You can arm/disarm and monitor your home via the telephone.
a. Enter the password followed by the PROG
b. A will flash on the screen.
c. Press ARM/DISARM
d. Using the */UP
represents the # of rings before the auto dialer picks up) followed by the
ARM/DISARM
e. Press the PROG
NOTE: You cannot use an answering machine with this feature. If you want to be able to
call in to the auto dialer you must program it to answer before your answering machine
does. Example if your answering machine answers after 4 rings, you must set the auto
dialer to answer at 3 rings.
10. TO PROGRAM ENTRY DELAY TIME: (Amount of time you need to deactivate
system once you have entered your residence)
a. Enter password followed by PROG
b. ENTRY will flash on the auto-dialer screen.
c. Press the ARM/DISARM
d. Using the */UP
Press ARM/DISARM
entry delay time.
e. Press the PROG
TO TEST MEMORY DIALLING
In standby mode, press and hold the PROG
will hear a short beep. Key in the memory location of the telephone number, i.e. 1 – 5. The
telephone number stored in specified memory location will automatically be dialed. Press
the PROG button to stop the dialing. The auto dialer must be connected to a land line
in order for this function to work. If not connected then you will hear 4 short beeps.
Page 8 of 17 5/11/2012
button to confirm.
and #/DOWN buttons to select cycle times between 1 and 5
button to confirm.
button four (4) times to exit set up mode.
button to confirm.
and #/DOWN
button to confirm.
button three (3) times to exit set-up mode.
button to confirm.
and #/DOWN
to confirm the number of seconds you require for the
button twice (2) to exit set-up mode.
button six (6) times.
th
ring.
button seven (7) times.
buttons select 3, 5, 7 or 10 (which
button eight (8) times.
buttons select the seconds 0,5,10,15 or 20.
button for at least 3 seconds, you