To Disarm The System; Panic Button - Ideal Security SK633 Owner's Manual

a. If the auto-dialer (in ARM mode) receives a signal from any sensor, the screen will
display TRIGGER with the zone number. After the delay entry time it will sound a
SIREN for 30 seconds on, 30 seconds off and 30 seconds on, and will automatically
dial all the numbers stored, one by one, for the CYCLE (amount of times the
numbers are dialed) you have chosen. The receiver of the phone call will hear one
beep cycle for zones 1-7 and 8S, two beep cycles for 24hr zone and four beep
cycles for PANIC. The receiver of the call can then call a neighbor, or take other
appropriate action.
b. In ARM mode, if the auto-dialer is set to SIREN OFF, the numbers stored will be
dialed silently. No siren will be heard from the installed location. When the call is
answered you will hear the sequence of beeps and know which zone was triggered.

3. TO DISARM THE SYSTEM

a. Enter password followed by the ARM/DISARM
press on DISARM
b. You will hear one beep and the ARM icon will disappear from the auto-dialer
screen to confirm that the Auto-Dialer has been DISARMED.
NOTE: In the 24HR zone the sensors will trigger the auto-dialer in ARM or DISARM
mode and start dialing the numbers stored for the amount of time programmed.
a. Before dialing the auto dialer will detect if a phone line is connected, if no
telephone line is connected the auto dialer will beep 4 times then the alarm will
sound without dialing.

4. PANIC BUTTON

a. If you press "PANIC"
will sound instantly for 30 seconds, then off for 30 seconds, then on for 30 seconds
and then off, and the auto-dialer will begin dialing the stored numbers immediately.
b. To stop the alarm sound and the dialing, enter password then press
ARM/DISARM
5. REMOTE CONTROL BY TELEPHONE OPERATION. (What you can do when
you receive a call from the system)
How to respond to a telephone alarm call.
a. Answer the call. You will hear one of the following:
a. 1 beep cycles is for zones 1-7 and 8S
b. 2 beeps cycles is for zone 24hr
c. 4 beeps cycles is for PANIC
b. You may enter the following codes on your phone key pad. Once code is entered
you will hear a beep for confirmation.
 Function
 Room Monitor
 End of Call
 DISARM System
Page 12 of 17 5/11/2012
button on the remote.
button on auto-dialer or remote control
button or press the DISARM
Press Key
1#
3#
6#
button on the auto dialer. Or
, the ALARM
button on the remote.