Ideal Security SK633 Owner's Manual page 14

NOTE: Arming system while in Home mode will deactivate Home mode. When you
disarm the system you will have to press the Home button again if you want to return
to Home mode. In Home mode the only thing the system does not do is dial out or
sound alarm for zones 1-7 and 8S. For zones 24hr and REMOTE they will trigger and
dial out.
Enabling and Disabling sensors when in home mode.
When in HOME mode all sensors will send signal to auto dialer and you will hear a chime.
If you have one or more sensors that you do not wish to have them send a signal to the auto
dialer, example a contact on a patio door that is in zone 3, then you would disable zone 3.
Zone's 1-7 you can disable each one of them, zone 8S you have to either enabled or disable
all sensors in that zone, you cannot pick only one. Zones 24hr and REMOTE cannot be
disabled. Factory preset is all sensors are on and will activate chime when triggered. To
turn off a sensor follow these instructions.
a. Enter password followed by pressing the Home button.
b. Zone one will flash on the LED screen.
c. Using the */UP
the setting for.
d. Press ARM/DISARM
#/DOWN buttons select ON or OFF. Press ARM/DISARM
confirm.
e. Press the Home button once to exit home-setup.
BATTERY LOW LED INDICATOR
When the Battery Low LED flashes once every 1.5 seconds, it indicates that the
battery power in auto-dialer is running low. Replace the batteries immediately.
If batteries are low, a false signal may be triggered and the auto dialer may start dialing.
Batteries in all units should be replaced every year like your smoke detectors.
VIEW FUNCTION
View Triggered Events
If alarm has been triggered it will flash on the LED screen. To view, in standby mode,
press #/DOWN button to view the last 5 triggered Events. Once viewed, TRIGGER
will disappear from the screen.
View stored telephone numbers
In standby mode, press */UP
NOTE: If no buttons are pressed for 10 seconds, the auto-dialer will automatically exit
view mode.
TO LEARN WIRELESS SENSORS OR REMOTE CONTROL CODES TO THE
TELEPHONE DIALER.
Page 14 of 17 5/11/2012
and #/DOWN buttons select the zone you want to change
button to confirm, the using the */UP
to view stored telephone numbers.
&
button to
HOME