Ideal Security SK633 Owner's Manual page 11

BATTERY LOW INDICATOR
When batteries are low, the LED will flash on 3 seconds and off 1 second. Replace the
batteries immediately, to maintain proper detection. If batteries are low they may send a
false signal to the auto-dialer. Batteries in all units should be replaced at least once per year
like your smoke detectors.
MODEL 629 WIRELESS REMOTE CONTROL
Install the CR2032 battery included into the remote control as shown below.
• Remote controls for Arm
• Remote range from receiver is up to 25 meters (80 feet)
If the remote has to be moved closer to the receiver in order to function please replace
batteries.
The battery life is about six months under normal use.
TO TEST THE WIRELESS SENSOR TRANSMITTING RANGE
After selecting a location for the units, but before installing permanently, you
should test the signal range of all units. Press the HOME button on the side of the auto-
dialer, wait 60 seconds at which time you will hear a beep. Then trigger the wireless
sensors. The auto-dialer will receive a signal and a chime will sound. If you do not hear a
chime and the zone is not flashing on the auto-dialer screen, the sensor may be out of range
of the auto-dialer. Repositioning either the sensor or auto-dialer should fix this problem.
Press HOME button again to exit test mode.
OPERATION
1. TO ARM THE SYSTEM
a. Enter password followed by the ARM/DISARM
b. Three short beeps will sound and the ARM icon will show on the auto-dialer screen.
c. You can also press the ARM
auto dialer.
d. Wait 60 seconds for a short beep. The auto-dialer is now set at ARM and ready to
receive signals.
e. When the system is armed (ARM), if a door or window is open the auto dialer will
beep for 5 seconds and the screen with show "CLOSE PLEASE" and also indicate
the zone number. If the door or window is still not closed it will start dialing after
60 seconds.
2. ALARM
Page 11 of 17 5/11/2012
, Disarm and Panic
button on the remote control unit to ARM the
button.
HOME HOME