Table of Contents
Advertisement
[Alarm Environment] Page
This page sets up the alarm environment.
This page can be used during access using
"admin" or "operator".
Click [Advanced Settings] in the side menu, and
0
click [Alarm Environment].
Press the [OK] button to enable the new
0
settings.
If the [OK] button is pressed upon entering an
0
invalid value, a warning message will appear
and the entry will be denied. Press the [Cancel]
button to restore the invalid entry to the value
before the change was made. If you press the
[Cancel] button, other changed items will also be
restored to the values before the change was
made.
Settings
.
* Setting values with R are default values.
[Advanced Settings] Page - [Alarm Environment] Page
42
Alarm Output
Configure settings related to alarm output from an
alarm output cable or connector.
9 Duration
Set the output duration for [Manual Output].
[Set values: R0, 100 to 1000 to 5000] msec
9 Manual Output
Manually operate alarm output.
The current output status is displayed on the right
side. When [Duration] is set to "0", pressing the
[Make] button sets the alarm to make output, and
pressing the [Break] button sets the alarm to break
output.
When [Duration] is set to other than "0", pressing
the [Make] button sets the alarm to make output
only for the output duration time, and then changes
it to break output.
When [Duration] is set to other than "0", pressing
the [Break] button sets the alarm to break output
only for the output duration time, and then changes
it to make output.
[Set values: Make, RBreak]
Advertisement
Table of Contents
