Quick Start For The Vc Series Mixer; Unpack And Connect; Power And Setup; Fine Tuning - Intelix 4001 VC User Manual

Vc series mic/line mixers
Table of Contents

Advertisement

Intelix VC Series Mic/Line Mixer User Manual
Ensure adequate ventilation is provided on the sides, ambient air temperature does not
exceed 72 degrees F, and an open rack space is left above and below the units.
To minimize hum in the system, avoid placing cables near EMF-producing devices such as
electrical motors, fluorescent lights, AC power lines, and SCR dimmers.
Keep the mixer and other equipment clean and free of dust by occasionally wiping with a soft,
damp cloth.
Protect the mixer from electrical damage by disconnecting it from the power source whenever
it will be unused for a week or longer.

1.3 Quick Start for the VC Series Mixer

1.3.1 Unpack and connect

1. Check mixer for shipping damage.
2. Turn both mixer and amplifier volume controls to zero.
3. Connect inputs and set the input pad switch for each channel to the appropriate level (either
mic or line). Set all unused channels to line level.
4. Connect output and set the output pad switch at the appropriate (either mic or line) level.
1.3.2 Power and set up
1. Connect mixer's AC power supply.
2. Power up mixer and amplifier.
3. Adjust the input volume for each channel by performing audio level tests. If necessary,
adjust the gain for individual channel(s).
4. Adjust the amplifier's volume controls and master output volume.
5. Adjust individual channel volume knobs to achieve the desired mix.

1.3.3 Fine tuning

1. In the event of excess bass, set the low cut filter switch to on.
2. If condenser mics are not otherwise powered, set the phantom power switch to on.
3. For VCX models only, increase the intelligibility of the signal by setting the Aphex® Aural
Exciter switch to on. In the event of excessive output level, set the limiter switch to on.

1.3.4 Optional: special features activation

Attach the DC control points and audio bus connections to the 25-pin connector on the rear
panel of the mixer. This will serve as an insert patch and allow linking, as well as enable
remote volume control, mute control, and duck control.
intelix
7

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

4001 vcx8001 vcx8001 vc

Table of Contents