Intelix VC Series Mic/Line Mixer User Manual
9.3 Individual Channel Patching
The use of the 25EXT card enables audio insert patching into each
input channel. With this feature each channel can:
1) send its output to another device for processing and route
the processed signal back to the mixer for inclusion in the
master output patching.
2) Direct Out; sends a channel to an external device and
normally through the mixer.
9.3.1 Patching instructions
1) Remove the channel's jumper from P2.
2) Move the channel's jumper on P3 to the insert patch position.
3) To patch the channel's output to an external device, connect the channel's "out" pin
to the input of the external device (see DB25 pinout above).
4) To patch an external signal into the channel, connect the external device's output into
the channel's in pin (see DB25 pinout above).
9.3.2 Direct outs
For creating direct outs, follow the directions for patching above except do not remove
jumper from P2. This allows access to a channel's preamp output, but does not remove it from
the mixer's summing bus.
9.3.3 DC control and patching functions combined
As can be seen from the drawing of P3 on page 31, channels 1, 3, 5, and 7 have two jumper
positions each. This means that those channels can and may be jumpered for both remote
control functions, and insert patching functions.
32
The pinout of 25EXT's
DB25 connector config-
ured entirely for audio
patch control.
intelix