Setting Channel Duck Details; Duck Trigger Channel Selection - Intelix 4001 VC User Manual

Intelix VC Series Mic/Line Mixer User Manual
Four main components must be adjusted for automatic ducking:
1) Duck Activate Channel Pins (P13) select duck triggering channels.
2) Duck Output Channel Pins (P11, P19) allow each non trigger channel to be ducked
or unducked.
3) Duck Amount Pot (RP13) set amount of duck (0--100 dB) for ducked channels.
4) Duck release time pot (RP 14) sets duration of hold time after duck is released (.5 -
5sec) for ducked channels.

7.4.1 Setting channel duck details

Two selection headers are used to set the order of the channels for ducking. There are three
choices for each channel: trigger, ducked, and non-ducked.

7.4.1.1 Duck trigger channel selection

To select a channel to activate the duck circuitry (i.e.; to be a duck trigger channel) jumper the
pins for that channel on P13 shown above.
If the channel is selected, any signal present on that channel will activate the duck. (On VCX
models, the green LED comes on when signal is present.
Note: Never select a channel to be a duck trigger and ducked at the same time.
intelix
23