Master Output Insert Patching; Balanced Line Link Input - Intelix 4001 VC User Manual

Intelix VC Series Mic/Line Mixer User Manual

8.2 Master Output Insert Patching

To use the patching feature of the VC mixer follow these directions:
1) Remove the top of the mixer chassis, and remove jumper J1. For location of J1 see
Section 7.4.
2) Connect a wire from pin 12 of the DB25 connector to the input of the destination
device.
3) Connect a wire from the output of the destination device to pin 13 of the DB25
connector.
This drawing illustrates the function
of the patching feature of the VC
mixer. The summed bus output is
sent to an external device on pin 12
of the mixer's DB25. The external
device's output is sent back to the
mixer on pin 13 of the mixer's
DB25. Note that jumper J1 is
removed for insert applications.
Note: If a patched application is no
longer desired, the jumper J1 must
be replaced.

8.3 Balanced Line Link Input

This feature allows the addition of a balanced line level audio input to the mixer's final output.
There is no input level control for this input.
To add a balanced line input follow these instructions:
If the incoming signal is balanced:
1) Connect a wire from the signal's + side to pin 1 of the mixer's DB25
2) Connect a wire from the signal's - side to pin 2 of the mixer's DB25
3) Connect the signal ground from any ground pin of the DB25 connector
If the incoming signal is unbalanced:
1) Connect a wire from the signal to pin 1 of the mixer's DB25 connector.
2) Connect a wire from the ground of the external device to a ground pin
28
connector.
connector.
to the signal ground of the external device.
on the mixer's DB25 connector.
intelix