Technical Specifications - Intelix 4001 VC User Manual

Intelix VC Series Mic/Line Mixer User Manual

12.0 Technical Specifications

Intelix VC Series mic/line mixers come in two models: the standard VC in 4 or 8-channel, featuring a compressor/limiter
and low cut filter; and the enhanced VCX in 4 or 8-channel, featuring a compressor/limiter, low cut filter, APHEX Aural
Exciters, priority channel autoducking, individual channel signal present and clip LEDs, master output VU metering, and
an insert patch or direct out for all channels. All units are linkable.
GENERAL
Frequency Response
Max Voltage Gain
Signal to Noise
Equivalent Input Noise
Crosstalk
Bar Graph
Reading
Attack
Decay
Phantom Power
Signal Present Indicators
Input Clip Indicators
Limiter Threshold
Adjustment
Duck level Adjust Range
Duck Release Time Adjust
Range
Aux DC Volume Control
Voltage
Nominal Remote DC Volume
Control Resistance
Power Requirements
Dimensions
Shipping Weight (average)
36
±.5 dB from 20 Hz to 20 kHz
+0, -3 dB from 10 Hz to 30 kHz
96 dB
Ref +26 dBu @ 54 dB
sys gain = 90dB
-129 dB @ 150 Ohms,
20 Hz to 20 kHz
better than -90 dB
-18, -12, -6, -3, 0, +3, +6, +12VU
Avg. or Peak, Main or Aux
1.7 ms
650 ms
+15V switchable,
bypassed in line mode
Peak reading, -10 dBu threshold
Peak reading, +13dBu threshold
-10 to +10dBu
0 to -100dB
0.5 sec to 5 sec
0-5V DC
10 kOhms (linear)
4001VC, 4001VCX, 8001VC:
16 VAC Center-Tapped, 21VA
8001VCX:
18VAC Center-Tapped, 21VA
19" x 9" x 1.75"
(48.2 cm x 22.8 cm x 4.4 cm)
12.5 lb (5.7 kg)
INPUTS
Input Trim Range 40 dB
Input Impedance 3.5 kOhms Mic / 15 kOhms Line
Nominal Source Impedance 150 Ohms
Mic/Line Pad -50 dB
Max Input Level +20 dBu (line pad on)
Low Cut Filter 12 dB per octave @ 120 Hz
Aux Input Impedance 20 kOhms balanced
OUTPUTS
Output Impedance (balanced)
(unbalanced)
Nominal Load Impedance 600 Ohms
Nominal Level +4 dBu RMS
Maximum Level +26 dBu RMS (balanced)
Main Out Mic/Line Pad -50 dB
440 Ohms
220 Ohms
intelix