Ducked And No Duck Channel Selection; Adjusting Duck Circuitry - Intelix 4001 VC User Manual

Intelix VC Series Mic/Line Mixer User Manual
Channel will not
be ducked when
jumper is placed
in position A.

7.4.1.2 Ducked and no duck channel selection

To select a channel to be ducked, place a jumper between the two pins for that channel on P11
(as shown in position B).
To configure the channels that will not be ducked, place a jumper between the two pins for
that channel on P19 and P11 (as shown in position A).
Note: The jumper on the unducked channel is for noise immunity only. If you are short of
jumpers, simply remove them from unducked channels.

7.4.2 Adjusting duck circuitry

There are two adjustments to be made to optimize ducking performance: duck amount and
duck release time.
Note: Do not touch the potentiometers marked in red by the manufacturer; doing so may
void the warranty.
24
A B
Channel will be
ducked when
jumper is placed
in position B.
intelix