Mediamaster Installation; Preparation Of The Remote Control; Connection To The Satellite Antenna - Nokia MEDIAMASTER 9701 S GOLD BOX Owner's Manual

MEDIAMASTER INSTALLATION

The Mediamaster package shall include the following
components:
• Mediamaster
• Remote control with 2 AAA batteries
• SCART cable (type approved – 1 metre)
• Antenna / RF cable (double screened– 1.5 metres)
• Instruction for use (this document)
• Mains cable
• Phone cable (10 m.)
• Phone adapter
• Light Card or "TELE
SCART plugs
Two SCART plugs are arranged at the rear of Mediamaster (see
the figure). While connecting other devices to these plugs,
always use type approved SCART cables (just as those
supplied). The market can also offer "cheaper" SCART cables,
but their use might compromise the quality of the image.

Preparation of the remote control

• Remove the cover of the remote control battery compartment.
• Insert 2 AAA batteries (1.5 V) as it is shown by the figure.
Observe the polarities shown by the + and – symbols inside
the compartment.
• Reassemble the cover.

Connection to the satellite antenna

Assembly of the F connectors on the cable
•
Prepare each end of the cable as it is shown by the figure.
It will be necessary to fold back the outer braid (as it is shown).
•
Insert the F connector on the cable. Rotate it clockwise to
fasten it onto the braid.
•
Make sure 3 mm. wire will protrude from the connector.
Installation of the satellite antenna
• To install the antenna, refer to the "Instructions for the
assembly of the satellite antenna".
• Connect the coaxial cable complete with F connectors from
the LNB on the satellite antenna to the "ANTENNA" plug on
the rear panel of Mediamaster (or on the DiSEqC switch for
dualfeed antennas).
GB 8
+
DIGITALE Welcome Kit"
SCART cable RF cable
Phone cable
(10 m.)
Phone adapter
Instructions
Light Card
for use
SCART
15 mm
Mai n s
cable
Remote control
8 mm
F Connector
3 mm
IT 8