Main Board; Bridge Battery - NEC VERSA LXi Service And Reference Manual

Main Board

Use the following procedure to remove the main board from the system.
Remove the keyboard, front cover, top cover, LCD panel, and audio board from the system.
1.
Locate and remove the three screws securing the main board to the system.
2.
A – Screw
Disconnect the hard disk drive cable from connector P3 on the main board.
3.
Disconnect the diskette drive cable from connector P4 on the main board.
4.
Disconnect the bridge battery cable from connector P1 on the main board.
5.
Remove the main board from the system.
6.

Bridge Battery

Use the following steps to remove the bridge battery from the system.
Remove the keyboard, front cover, top cover, LCD panel, audio board, and main board
1.
from the system.
Note
The bridge battery cable should already have been disconnected from connector P1 on
the main board if the main board was removed.
Carefully pry the bridge battery up and remove it from the system.
2.
3-22 Disassembly and Reassembly
Removing the main board screws