Enabling The Bios Flash Switch - NEC VERSA LXi Service And Reference Manual

Enabling the BIOS Flash Switch

Before performing the BIOS update, be sure to enable the BIOS flash switch. Set switch 5 to
"ON" before performing the BIOS update.
from yourself and your clothing by touching a nearby metal surface.
Follow these steps to enable the BIOS flash switch.
Make sure the system is powered off and that no peripheral devices are attached.
1.
Open the LCD panel.
2.
Locate the two keyboard retainers, press on and slide each one towards the outside edge of
3.
the system, and remove them.
Gently lift up the edge of the keyboard nearest the LCD and slide the keyboard toward the
4.
LCD screen to release the tabs that secure it.
from the system.
2-24 System Configuration and Setup
Before handling any internal components, discharge static electricity
Removing the keyboard retainers
Lifting the keyboard
Be careful not to disconnect the keyboard or keyboard cable entirely