Hard Disk Drive - NEC VERSA LXi Service And Reference Manual

To install a memory module, proceed as follows:
4.
Hold the SO-DIMM at a 60 degree angle and align the SO-DIMM contacts with the
!
socket in the system. Push the connector into the socket.
Press down on the edge of the SO-DIMM opposite the contacts until the lock tabs on
!
the sides snap into place, securing the module.

Hard Disk Drive

Use the following procedure to remove the hard disk drive. This procedure assumes the battery
has been removed from the system.
Close the LCD and turn over the system.
1.
Remove the disk drive as follows:
2.
Remove the screw that secures the hard disk drive.
!
Place your finger in the center notch of the hard drive lever and pull up the lever. Be
!
sure that both sides of the lever are raised. If you encounter any resistance when lifting
the lever, carefully loosen both sides of the lever before lifting.
A – Screw
B – Hard Disk Drive Lever
3-8 Disassembly and Reassembly
Installing the SO-DIMM
Hard disk drive in the bay
C – Hard Disk Drive