Table of Contents
Advertisement
Enabling the BIOS Flash Switch
Before performing the BIOS update, be sure to enable the BIOS flash switch. Set
switch 5 to "ON" before performing the BIOS update.
Follow these steps to enable the BIOS flash switch.
1.
Make sure the system is powered off and that no peripheral devices are attached.
Open the LCD panel.
2.
3.
Locate the two keyboard retainers, press on and slide each one towards the outside
edge of the system, and remove them.
3-26 Using the BIOS Setup Utility
Removing the keyboard retainers
Advertisement
Table of Contents
