Mackie Digital 8 Bus Owner's Manual page 82

MASTER
PAN SOLO
3. Rotate the Master V-Pot to the right to
adjust the overall Aux Out level for the
selected aux bus.
TO ADJUST THE AUX SEND LEVELS
From the screen:
1. Click on one of the AUX buttons above
the MASTER V-Pot. The Master V-Pot
becomes the Master Aux Send Level
control for the selected aux bus, and
the channel V-Pots become the channel
Aux Send Level controls.
2. Click and hold on the channel V-Pot,
and move the mouse up or to the right
to increase the signal in the selected
aux bus, and down or left to reduce the
amount of signal in the selected Aux
bus. The box below the V-Pot indicates
the Aux level numerically, from OFF to
+10, with "0" representing unity gain.
The Aux levels are also indicated as
bar graphs just above the EQ section
on each channel.
3. Click and hold the Master V-Pot and
move the mouse up and down to adjust
the overall Aux Out level for the se-
lected aux bus.
The Master L-R meters can indicate the
overall aux send level if you press the
SOLO button in the Master V-Pot Section.
Mono master aux sends (1–8) are indicated
equally on the Master L-R meters, and
stereo Aux Master aux sends 9–10 and
11–12 are indicated in stereo on the Master
L-R meters.
Note: You can also click and hold on any
auxiliary bar (level or pan) and drag to set
levels. Clicking and holding the right mouse
button while dragging across the screen
will set adjacent channels (auxes) to the
same levels as the original clicked (aux) level.
Starting a New Session
6-5