Mackie Digital 8 Bus Owner's Manual page 38

SETUP
SAVE SAVE AS...
GROUP GENERAL
D8B
56 INPUT / 72 CHANNEL DIGITAL MIXER
( G E N E R A L
L a n g u a g e S u r r o u n d
D8B
56 INPUT / 72 CHANNEL DIGITAL MIXER
< - R e c 1 - 8 R e c 9 - 1 6
D e v I D 0 D e v I D 1
D8B
56 INPUT / 72 CHANNEL DIGITAL MIXER
< - 0 0 : 0 0 : 0 0 : 0 0
< < > >
D8B
56 INPUT / 72 CHANNEL DIGITAL MIXER
< - ( S I N G L E
O n O f f
D8B
56 INPUT / 72 CHANNEL DIGITAL MIXER
< - M I D I M A P 1
< < S c a n > >
NEW LOAD
PLUG INS DIGITAL I/O
S E T U P P g 1 - > )
M I D I A u t o S a v e
R e c 1 7 - 2 4 ( M M C ) - >
D e v I D 2
( M T C O F F S E T ) - >
Z e r o - S e t S e t
B U T T O N R E C O R D ) - >
( L O A D T E M P O M A P ) - >
R e s e t O p e n
TO CONFIGURE MIDI PARAMETERS
From the console:
1. Press the GENERAL button in the
Setup Section. The General Setup
menu appears in the Fat Channel
Display.
2. Press the SELECT button below MIDI
in the Fat Channel Display. The MIDI
menu appears.
3. The default Device ID assignments
appear in the display. To reassign a
device, turn the V-Port below the
Device ID.
4. Press the NEXT button to scroll to
page 2 of the MIDI menu, to set MTC
offset. Press the SELECT button below
the arrows in the display to set the
amount of offset. Then press SELECT
below "Set." Press SELECT below "Zero-
Set" to reset the offset back to zero.
5. Press the NEXT button to scroll to page 3
of the MIDI menu. Press the SELECT
button below "On" or "Off" to turn on
or off the single button record option.
Tip: We recommend you leave the
single button record OFF. This provides
an extra measure of safety to prevent
you from accidentally putting your
recorder(s) into record mode.
6. Press the NEXT button to scroll to
page 4 of the MIDI menu. Press the
SELECT buttons below the arrows to
see the available SMFs in the display.
Press the NEXT button to get to the
"ChangeDir" menu, for stepping through
the various directories, or for changing
drives. Press the PREVIOUS button to
get back to the "Load Tempo Map"
menu. Press the SELECT button below
"Open" to load the selected SMF Tempo
Map. Press the SELECT button below
"Reset" to return to the default settings.
7. Press the PREVIOUS button to get
back to the General menu, or press the
GENERAL button to return to normal
Fat Channel operation.
3-5
Start-Up