Looping Between Two Locate Points - Mackie Digital 8 Bus Owner's Manual

SET TIME
SMPTE VIEW
5-16
Preparing for a Session
POSITION
HOURS MINUTES SECONDS FRAMES
BARS BEATS TICKS
1 2 3
6 7 8
ENTER LOOP STORE
REWIND FAST FWD STOP
SHUTTLE
Looping Between Two Locate
Points
TO LOOP BETWEEN TWO LOCATE POINTS
RANGE
FROM TO
From the console:
1. Create locate points at the starting
LOOP
4 5
2. Use the number buttons to type in the
9 0
LOCATOR SNAPSHOT
MODE
PLAY RECORD
3. Press the LOOP button in the
JOG & SHUTTLE
JOG
4. Press the PLAY button in the
Note: Pressing PLAY when the POSITION
display indicates a time before the first
Loop point causes the transport to play
through to the second Loop point and then
begin repeating from then on. Pressing
play when the POSITION display indicates
a time after the second Loop point simply
causes the transport to play through to the
end of the tape/hard disk, etc. No looping
will occur.
TO LOOP BETWEEN TWO LOCATE POINTS
From the screen:
console.
point and ending point of the desired
loop, as described previously.
two-digit locate number for the
starting point, and then press ENTER.
The number appears under FROM in
the RANGE display.
Transport Section. Use the number
buttons to type in the two-digit locate
number for the ending point, and then
press ENTER. The number appears
under TO in the RANGE display.
Transport Section. The recorder(s) will
play the section from the starting
point to the ending point, and will
continually repeat between these two
points until the STOP button is
pressed.
This function is only available from the