Mackie Digital 8 Bus Owner's Manual page 100

MASTER OUT
L R
MAIN
L R
L
NEAR FIELD
L R
R
MASTER OUT
TAPE 1-8 TAPE 9-16 TAPE 17-24
ANALOG I/O ANALOG I/O ANALOG I/O
TAPE IN/OUTS
TO ROUTE TAPE RETURNS TO THE MAIN
OUTPUTS
From the screen:
1. Select Fader Bank 2 by clicking on the
2. Click and drag across the channel L-R
3. Connect the MASTER L-R outputs on
CR
CR
Input Sensitivity Adjustment Procedure
for Channels 25–48
(–15 dB FS on the meter is equivalent to
+5 dBu analog)
FOLLOW THIS SENSITIVITY ADJUST-
MENT PROCEDURE FOR EACH
CHANNEL IN USE:
1. If you're starting from scratch, it's a
2. Connect the tape outs from your re-
3. We're assuming you already have the
TAPE button.
assign buttons on the channels that are
going to be mixed down to two tracks.
the Digital 8•Bus' rear panel to the in-
puts of your two-track master tape
recorder.
good idea to normal the console (also
called "zeroing") to some starting
point, such as all level controls down,
and EQ and pan controls centered.
corder to the TAPE IN connections on
the rear panel of the Digital 8•Bus.
Control Room outputs connected to an
amplifier/speaker combination.
Starting a New Session
6-23