Monitor Mode Commands - Lantronix C 7/01 User Manual

Monitor Mode

Monitor Mode Commands

The following commands are available in Monitor Mode. Many commands have an IP
address as an optional parameter (xxx.xxx.xxx.xxx). If the IP address is given, the
command is applied to another Device Server with that IP address. If no IP address is given,
the command is executed locally.
Note: All commands must be given in capital letters, with blank spaces
between the parameters.
Command
DL
VS x.x.x.x
GC x.x.x.x
SC x.x.x.x
PI x.x.x.x
AT
TT
NC
RS
SI
xxx.xxx.xxx.xxx:yyy.
yyy.yyy.yyy
QU
G0, G1, ....,GE, GF
S0, S1,...,SE
Table B-1: Monitor Mode Commands
Command Name
Download
Version
Get Configuration
Send Configuration
Ping
ARP Table
TCP Connection
Table
Network Connection
Reset
Send/Set IP Address
Quit
Get configuration
from memory page
Set configuration to
memory page
Function
Download firmware to the
the serial port in hex format
Query software header record (16 bytes) of
Device Server with IP address x.x.x.x
Get configuration of Device Server with IP
address x.x.x.x as hex records (120 bytes)
Set configuration of Device Server with IP
address x.x.x.x from hex records
Ping Device Server with IP address x.x.x.x to
check device status
Device Server
Show the
Show all incoming and outgoing TCP connec-
tions
Device Server
Show the
Device Server
Reset the
Remotely assign an IP address to a Device Server,
where xxx.xxx.xxx.xxx is the IP address, and
yyyy.yyy.yyyy.yyy is the two-part identification
number at the bottom of the label, converted to
decimal and written twice.
Exit diagnostics mode
Gets a memory page of configuration information
from the device.
Sets a memory page of configuration information
on the device.
B-2
Troubleshooting
Device Server via
's ARP table entries
's IP configuration
's power