Aps Configuration Utility - Lantronix C 7/01 User Manual

Getting Started
AutoIP is not intended to replace DHCP. The Device Server will continue to look for a
DHCP server on the network. If it finds a DHCP server, the Device Server will switch to
the DHCP server-provided address and reboot.
Note: If a DHCP server is found, but it denies the request for an IP address,
the Device Server does not attach to the network, but waits and retries.
AutoIP can be disabled by setting the Device Server's IP address to 0.0.1.0.

APS Configuration Utility

You can manually assign the IP address using the APS Configuration Utility, which you
can install from the APS CD and then select the protocol (firmware) to suit your needs.
1
Insert the APS CD into your CD-ROM drive.
2
Respond to the installation wizard prompts.
Note: If the CD does not launch automatically, click the Start button on the
Windows Task Bar and select Run. In the Open field, enter your drive
letter, colon, backslash, and setup.exe (e.g., E:\setup.exe). Click OK.
3
Click the Start button on the Windows Task Bar, and select Programs-->APS
Config-->APS Config. The Configuration Utility window displays.
Figure 3-1: Configuration Utility Window.
3-3
Assigning the IP Address