Grandstream Networks GXW410X User Manual page 25

Echo Cancellation
Channel specific Setting
DTMF Method
No Key Entry Timeout
Local SIP Listen Port
SRTP Mode
Round Robin and/or
Flexible
Prefix to specify Port
(1 stage dialing method)
When set to Y, Echo cancellation is enabled.
Channel specific settings mentioned below.
This parameter specifies the mechanism to transmit DTMF digits. There are7 modes
supported: in audio which means DTMF is combined in audio signal (not very reliable
with low bit­rate codec), via RTP (RFC2833), or via SIP INFO. Multiple DTMF
transmission schemes can be selected.
1 – in­audio
2 – RFC2833
3 – in­audio and RFC2833
4 – SIP Info
5 – in­audio and RFC2833
6 – SIP Info and RFC2833
1. 7 – in­audio, RFC2833, and SIP Info
Default is 4 seconds.
Default is ch1­8:5060++;. The ++ indicates increments by 2, so port 1 is set at 5060,
port at 5062 and so on. This setting can be used with Round Robin and/or Flexible
setting below to configure different ports to be placed under different Round Robin
groups.
Default is disabled for all ports. The user can select to either enable it but not force it
or force it on an individual port basis. When used the communication will be sent
using Secure RTP.
Default is rr:1­8;
The syntax is pretty straight­forward here. The rr stands for Round Robin and the
numbers stand for the ports that belong to that round robin group.
For example:
rr:1­8; ­> Round robin within the first 8 ports i.e. outgoing calls will be forwarded to
the next available port within the group of ports 1 to 8.
rr:1,3­6,8;rr:2,7; ­> Round robin within port 1,3,4,5,6 and 8; Second round robin group
within ports 2 and 7 i.e. outgoing calls to ports 1,3,4,5,6 and 8 will be forwarded to the
next available port within this group ONLY. Outgoing calls to port 2 and 7 will be
forwarded to the next available port between ports 2 and 7 ONLY.
** In order to terminate a call on FXO port 2 or 7 you will need to change its Local
SIP Listen port accordingly.
Default is 99.
Syntax to USE this feature: prefix# (that is 99) + ch# (could be anything from 1 to 8) +
dialing# will result in this call forwarded to FXO port (ch#) immediately.