Blower Installation - Quadra-Fire COLBAY-INS Owner's Manual

C. Blower Installation
Included in kit: Blower.
Tools required: Powered Phillips head screwdriver.
Turn off gas and disconnect appliance from electricity.
Remove logs and burner from appliance. Remove blower
access cover in bottom of firebox by removing the screws.
Retain screws for reassembly.
Figure 10.3
Disconnect wires from the snap disk on back of access
cover.
Figure 10.4
Lift blower off of studs and pull through opening.
Figure 10.5
26 Quadra-Fire • COLBAY-INS • 7002-109 Rev. N • 8/10
Disconnect wires from the blower.
Figure 10.6
Remove grommet retainer from old blower and install on
new blower.
Figure 10.7
Installation is the reverse of removal.