Blower Installation - Quadra-Fire HUDSON BAY HUDBAY-FS Owner's Manual

H. Blower Installation
KIT CONTENTS: Blower; 2 female spade wire connectors.
TOOLS REQUIRED: Powered screwdriver with a #2 Phillips
head bit.
The blower motor comes standard with two male spade
wire connectors. If your appliance has a different
connection, use the two female spade wire connectors
provided to modify the appliance wiring harness.
Disconnect power to the appliance. To access
Figure 8.20 -
the blower, open the door located on the front of the pedestal.
Remove the two screws holding the blower bracket in place.
Fan Assembly
Figure 8.23 Blower Wiring Diagram
Page 32
Thermal Disk
F
F
BLK
F
M
F
BLK
Ground
BLK
M F
Quadra-Fire • Hudson Bay • 7003-121_R20 • 11/14
Disconnect wires to the blower motor. Remove
Figure 8.21 -
the blower from the bracket.
Install the new blower by slipping grommets
Figure 8.22 -
over studs on the blower bracket. Reinstall the blower and
bracket. Connect the wires. Install screws. Restore power
to the appliance.
WHT
F = Female spade connector
M = Male spade connector
M
Power Cord (110 VAC)
GRN
Strain Relief Bushing
Fan Speed Control
WHT
BLK